CNV 1413

Highlights

• Low-cost converter
• Easy installation
• Flexible power supply 8 to 36 VDC
• Communication distance up to 1000 m
• Data rate max. 120 kBaud

Technical Data

Configuration of the Module

The configuration can be setup at factory or by the user by soldering little connections. So the user should have some experience in soldering for changing the configuration.

• Operation mode RS485 or RS422
• Operation as 2-wire RS485 or as 4-wire RS422
• Transmitter control DTR or RTS of RS232
• Transmitter control permanent, high- or low-active
• Receiver control permanent on or only when transmitter is off
• Pinning DCE or DTE (DCE: direct connection to DTE/PC/notebook; DTE: direct connection to DCE, TxD and RxD exchanged)

Bus Termination

The module consists of 2 termination resistors of 120 Ohm each. These resistors can be separately activated by external wires. One resistor is to be used for the receiver, the other for the transmitter. Only one of these resistors is to be used in RS485 applications.

Technical Specifications

Max. Baud Rate	max. 120 kBaud
RS232
– Used signals	TxD, RxD, DTR/RTS, GND
– Shorted signals	RTS + CTS, DTR + DSR + DCD
RS485/RS422
– Transmitter control	over DTR/RTS of RS232 or permanent
– Termination resistors	2× 120 Ohm, separately switchable
Supply voltage	8 to 36 V DC
Power consumption	70 mA at 8 VDC, 20 mA at 36 VDC (maximal)
Connection	on SUB-D connector of RS422/485
CE	EMC 2014/30/EU RoHS 2011/65/EU + 2015/863 LVD 2014/35/EU
Operating temperature	0–50 °C
Storage temperature	-20 to +70 °C
Dimensions	55 × 18 × 62 mm