PM 9000

- Should only be used for spare parts requirements -

Highlights

• DIN rail mounting (35 mm / 32 mm G-rail)
• Especially qualified for installation in flat wall cases and terminal boxes
• At standard a lot of measuring ranges for different sensors
• Varied connections at digital IOs from PLC (also Mini-PLC)
• 10 parameter sets for a quick configuration
• Measuring during parameter setup
• Application as a nominal value transmitter

The PM 9000 is provided with 10 parameter sets. Each parameter set contains all adjustments including 10-point linearization. So the PM 9000 can be pre-programmed for 10 different areas of application. If required, the desired parameter set is selected and the instrument operates with these settings.

Technical Data

Analog Input Ranges

16 bit, 5 measurements per second, user scalable and tarable.

Voltage	±20.00 V, ±2.000 V, ±200.0 mV, ±20.00 mV
Current	±20.00 mA, 0/4 to 20.00 mA
Angle potentiometer	0 to 100.0 %
Resistance	0 to 1,000 kOhm
DMS	1.5/2/2.5/3/3.3 mV/V ±100.0 % (4-wire)
Pt100	-200.0 to +800.0 °C (2-, 4-wire)
FeCuNi (J)	-100 to +800 °C
NiCrNi (K)	-100 to +1300 °C
PtRhPt (S)	0 to 1750 °C
Temperature compensation	internal, constant or without

Digital Input Ranges

Input voltage	24 - 60 V, isolated
Counter	24 bit, scalable, display range +99999 to -9999
– Incremental	1-, 2-, 4-fold to 2 kHz
– Impulse	max. 2 kHz, alternatively gate, direction, reset
Frequency	0.01 Hz to 10 kHz
Time	to 9999.9 s
Cycle	to 9999.9 s
Pulse duration	to 9999.9 s
Impulse/min	0 to 99999
Impulse/h	0 to 99999

Special Function

• Nominal value transmitter

Alarm Outputs

• 2 alarms with solid-state relays (24 VDC, 200 mA, short-proof), supplied via the main power supply
• Programmable functions: alarm point, hysteresis, switching characteristics, rise time and fall time delay; data source: direct input, mean, peak, valley value
• Direct connection to PLC

Analog Output

• Free scaling, isolated, 14 bit
• Voltage: 0 to 10 V, max. 10 mA
• Current: 0/4 to 20 mA, 500 Ohm burden
• Data source: direct input, mean, peak, valley value
• Error indication at current output
• Sensor break: > 22 mA
• Error: < 2 mA

Synchronous Serial Interface

• Isolated
• Connection of separate displays with serial input
• Connection to PLC resp. IO cards
• Measured value transmitting
• Control of transfer rate via PLC
• Minimum IO expense at the PLC

Software Functions

• User scaling
• Adjustable digital filter of 1st order
• Peak and valley detection
• User-defined linearization up to 10 points
• Taring
• Automatic reset of peak and valley detection
• Display of temperature in °C, °F or K
• Undisturbed measuring during parameter setup

Power Supply

• 18 - 36 VDC, polarity reversal protection